Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
843 Bucket Positioning Valve ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="workinprogress" data-source="post: 81655" data-attributes="member: 11273"><p>Well I replaced the Tilt Cylinder (was going to rebuild, but rod was bent due to the lack of bucket tilt stops) and now have built some stops to keep from bending it again. The bucket still will randomly drop away (not a free fall, but faster than usual) when lifting the lift arms. If I run the arms all the way down and bottom them out, it will then act normal( as a bucket should with a bucket position valve), but will then soon return to dropping the bucket when lifting, and will not allow you to tilt back up without setting the bucket down on its cutting edge, driving back while tilting back and lowering the arms. once it begins to do this, if I just try to tilt back, it will try to raise or lower the lift arms unpredictably while still tilting the bucket... This leads me to believe that the problem lies in the bucket position valve. Thoughts?</p></blockquote><p></p>
[QUOTE="workinprogress, post: 81655, member: 11273"] Well I replaced the Tilt Cylinder (was going to rebuild, but rod was bent due to the lack of bucket tilt stops) and now have built some stops to keep from bending it again. The bucket still will randomly drop away (not a free fall, but faster than usual) when lifting the lift arms. If I run the arms all the way down and bottom them out, it will then act normal( as a bucket should with a bucket position valve), but will then soon return to dropping the bucket when lifting, and will not allow you to tilt back up without setting the bucket down on its cutting edge, driving back while tilting back and lowering the arms. once it begins to do this, if I just try to tilt back, it will try to raise or lower the lift arms unpredictably while still tilting the bucket... This leads me to believe that the problem lies in the bucket position valve. Thoughts? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
843 Bucket Positioning Valve ?
Top