Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
773 lift and tilt very slow
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Fishfiles" data-source="post: 36750" data-attributes="member: 782"><p>the pump which controlls the bucket , lift , charge pressure and aux is the gear pump which is bolted to the end of the sunstrand tansmission pump , with out high flow or a attachment hydraulic release it would have two hoses going to it , one supply and one pressure , looking at the machine with the cab up it would be on the left side , they go for about 800 from the dealer , some models cost more , I have seen a site on line that sells them a little cheaper but have never dealt with them , it is not a very hard job to do , maybe 2 hours max to change out a pump if all goes well --------------if you took it off and opened it up you would look for a wear line inside the housing and or a groove cut into the end plate under wear the gears rotate on the plate , either spot will cause a loss of pressure and or cavation ------------does you oil get foamy ? -------it doesn't always get foamy when the pump is going out but sometimes it does</p></blockquote><p></p>
[QUOTE="Fishfiles, post: 36750, member: 782"] the pump which controlls the bucket , lift , charge pressure and aux is the gear pump which is bolted to the end of the sunstrand tansmission pump , with out high flow or a attachment hydraulic release it would have two hoses going to it , one supply and one pressure , looking at the machine with the cab up it would be on the left side , they go for about 800 from the dealer , some models cost more , I have seen a site on line that sells them a little cheaper but have never dealt with them , it is not a very hard job to do , maybe 2 hours max to change out a pump if all goes well --------------if you took it off and opened it up you would look for a wear line inside the housing and or a groove cut into the end plate under wear the gears rotate on the plate , either spot will cause a loss of pressure and or cavation ------------does you oil get foamy ? -------it doesn't always get foamy when the pump is going out but sometimes it does [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
773 lift and tilt very slow
Top