Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
751 peugeot XUD9 to Kubota V2203 conversion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Mrtwisty" data-source="post: 79480" data-attributes="member: 11403"><p>I have a 1995 751-C with a blown peugeot motor. I did not do my research before buying, ha ha. I have installation instructions for this conversion. I'm pretty confused on the hydrostatic pump procedure. since the peugeot powered loader is driven from the opposite side it says to take two pumps apart, then take out the four bolts out of the pump housing end cap on both pumps. then, rotate pump housing endcaps 180 degrees from there present location. then, reassemble the endcaps on pump halves. Any other info on the whole conversion procedure would be appreciated. I also have a parts list but i've read on this forum I believe, that parts from a 753 would work to do this conversion.</p></blockquote><p></p>
[QUOTE="Mrtwisty, post: 79480, member: 11403"] I have a 1995 751-C with a blown peugeot motor. I did not do my research before buying, ha ha. I have installation instructions for this conversion. I'm pretty confused on the hydrostatic pump procedure. since the peugeot powered loader is driven from the opposite side it says to take two pumps apart, then take out the four bolts out of the pump housing end cap on both pumps. then, rotate pump housing endcaps 180 degrees from there present location. then, reassemble the endcaps on pump halves. Any other info on the whole conversion procedure would be appreciated. I also have a parts list but i've read on this forum I believe, that parts from a 753 would work to do this conversion. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
751 peugeot XUD9 to Kubota V2203 conversion
Top