Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 rough running, backfiring
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="GILL" data-source="post: 68556" data-attributes="member: 265"><p>Well so far I've changed the plugs, points, condenser and rotor. I set the points to the gap in my bobcat book and put it all back together. It started easily as always and seemed to run o.k. I shut it down to tighten up fuel filter since it was dripping and then restarted with timing light installed. In the book it shows three marks on pulley but, I only have one cut on mine. The timing seemed way off by a couple of inches on the pulley. When I tried to adjust to tdc it caused the engine to run rough and die. So I rotated the distributor back and got it running again like it was. Now it seems to be running out of gas again. The longer I let it sit the longer it will run. Is it possible the fuel pump is bad (like was brought up before) and the fuel is getting by it and getting just enough gas to carb to allow it to run? There are two solenoids but it seems to get some gas. What do you guys think Thanks Greg</p></blockquote><p></p>
[QUOTE="GILL, post: 68556, member: 265"] Well so far I've changed the plugs, points, condenser and rotor. I set the points to the gap in my bobcat book and put it all back together. It started easily as always and seemed to run o.k. I shut it down to tighten up fuel filter since it was dripping and then restarted with timing light installed. In the book it shows three marks on pulley but, I only have one cut on mine. The timing seemed way off by a couple of inches on the pulley. When I tried to adjust to tdc it caused the engine to run rough and die. So I rotated the distributor back and got it running again like it was. Now it seems to be running out of gas again. The longer I let it sit the longer it will run. Is it possible the fuel pump is bad (like was brought up before) and the fuel is getting by it and getting just enough gas to carb to allow it to run? There are two solenoids but it seems to get some gas. What do you guys think Thanks Greg [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 rough running, backfiring
Top