Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
722 No Charge Pressure
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 79339" data-attributes="member: 82"><p>That is very odd, the shaft should go all the way through and be supported by the bronze bushing on the end plate. Could the end have been broken off?</p><p>I believe this shaft actually screws into the shaft through the drive pumps. It is made this way just in case the pump locks up it will break this shaft which is cheaper to replace than the entrie shaft through the pumps.</p></blockquote><p></p>
[QUOTE="Tazza, post: 79339, member: 82"] That is very odd, the shaft should go all the way through and be supported by the bronze bushing on the end plate. Could the end have been broken off? I believe this shaft actually screws into the shaft through the drive pumps. It is made this way just in case the pump locks up it will break this shaft which is cheaper to replace than the entrie shaft through the pumps. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
722 No Charge Pressure
Top