Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
722 Drive Motor Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="jerry" data-source="post: 76314" data-attributes="member: 931"><p>Is the plate brass faced or solid cast? If it's solid you could have it surface ground at a machine shop. If brass do as Tazza said , start with about 220 wet or dry and a sheet of glass with a little oil. Then finish with a finer grit. Change direction often when lapping it so you do not develop a pattern. It takes awhile but it works.</p></blockquote><p></p>
[QUOTE="jerry, post: 76314, member: 931"] Is the plate brass faced or solid cast? If it's solid you could have it surface ground at a machine shop. If brass do as Tazza said , start with about 220 wet or dry and a sheet of glass with a little oil. Then finish with a finer grit. Change direction often when lapping it so you do not develop a pattern. It takes awhile but it works. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
722 Drive Motor Problem
Top