Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
543 with slow lift/bucket action
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="elbowcarey" data-source="post: 69264" data-attributes="member: 6935"><p>Thanks. What do you need to use to check the pressure at the Aux. Conectors? Also in the manual for this machine it says that you can adjust the pressure without removing the relief valve by turning the allen screw under the cap clockwise to increase and counterclockwise to decrease. In another section it mentions adding shims will increase pressure and not to exceed 4 shims (.040) I see what you mean about getting a reading at the aux. couplers so system pressure can be benchmarked before adjusting, but what do you adjust first and is it safe to assume that if adjustments to raise the pressure to 1500 are not successful that the pump is in need of replacement? Or is there rebuild kits avaliable? Thanks again</p></blockquote><p></p>
[QUOTE="elbowcarey, post: 69264, member: 6935"] Thanks. What do you need to use to check the pressure at the Aux. Conectors? Also in the manual for this machine it says that you can adjust the pressure without removing the relief valve by turning the allen screw under the cap clockwise to increase and counterclockwise to decrease. In another section it mentions adding shims will increase pressure and not to exceed 4 shims (.040) I see what you mean about getting a reading at the aux. couplers so system pressure can be benchmarked before adjusting, but what do you adjust first and is it safe to assume that if adjustments to raise the pressure to 1500 are not successful that the pump is in need of replacement? Or is there rebuild kits avaliable? Thanks again [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
543 with slow lift/bucket action
Top