Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
4XX Aux Hydraulics Linkage
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="SkidRoe" data-source="post: 45711" data-attributes="member: 3290"><p>All done. I finished the install last night, after a good night of work on Monday. </p><p>I opted to go with the hard lines on the left boom arm, as room was tight and hoses did not route well. But from the hard lines on the boom to the control valve, the hoses worked nicely. </p><p>I had thought that pulling the control valve to put in the third spool was going to be a bear, but it ended up not being too bad.</p><p>Probably the worst part of the job was getting the control cable routed and adjusted just right. I ended up routing it back under the right hydro pump before looping back forward. Kind of time consuming, since everything is packed in there like sardines and there is not a whole lot of room for swinging wrenches.</p><p>One thing I did notice after I had it done is that when actuating the right stick, it seems to wack you right in the calf when you move it towards the left. Did Bobcat change the design of the stick on later models for for more leg clearance? I guess this may be something that I will need to get used to.</p><p>Cheers,</p><p>SR</p></blockquote><p></p>
[QUOTE="SkidRoe, post: 45711, member: 3290"] All done. I finished the install last night, after a good night of work on Monday. I opted to go with the hard lines on the left boom arm, as room was tight and hoses did not route well. But from the hard lines on the boom to the control valve, the hoses worked nicely. I had thought that pulling the control valve to put in the third spool was going to be a bear, but it ended up not being too bad. Probably the worst part of the job was getting the control cable routed and adjusted just right. I ended up routing it back under the right hydro pump before looping back forward. Kind of time consuming, since everything is packed in there like sardines and there is not a whole lot of room for swinging wrenches. One thing I did notice after I had it done is that when actuating the right stick, it seems to wack you right in the calf when you move it towards the left. Did Bobcat change the design of the stick on later models for for more leg clearance? I guess this may be something that I will need to get used to. Cheers, SR [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
4XX Aux Hydraulics Linkage
Top