Hydraulic pump mount bolt L175

Following my oil change the other night it became apparent that there was a full inch of oily dirt covering the inside of the bellypan. Tonight I dropped the main skidplate/cover to begin cleaning all that crap out of there and out falls a long 5/8 bolt with a giant washer. It is the bolt that goes up through a rubber mount/bushing and attaches the pump to the frame. My question is, how tight should this bolt be? Will it bottom out and actually get tight? or does it just compress the rubber and rely on that to keep it from falling out?

Broke down and bought a service manual and a parts manual. The mount isn't mentioned in the service manual at all, however it is shown in the parts manual. It looks just like an engine mount. I torqued it to 80ft/lbs

Farlsincharge said:

Broke down and bought a service manual and a parts manual. The mount isn't mentioned in the service manual at all, however it is shown in the parts manual. It looks just like an engine mount. I torqued it to 80ft/lbs

Click to expand...

Glad you got it sorted out.
Some times there are torque settings in the manual for bolt sizes so any bolt that size is torques to that tension, no matter where it is.