Recent content by sitkashedz

No, there is no nut on the outside of the hub for adjustment. I'm going to pull the inspection plate off and drain the oil to check for any noticeable debris. Sounds like I might be able to make an adjustment to the retaining plate for the bearings......hopefully. Just waiting on some schematics...

So I had to jack up my machine to fix a flat on the left rear today, and when I put the tire back on I noticed about a 1/4" of lateral play. I don't believe its a bearing because it only moves directly in and out when pulling evenly on each side of the tire. The play is coming from between the...

New to this forum and looking for any experience/thoughts on using a 272C with steel OTT vs a large frame CTL for mulching purposes? Will be varied terrain with some wet ground and brush/sapplings up to 5".Looking at a Fecon head. I would guess the machine would be used 30% for mulching and the...