Recent content by ruko_ruko

Thanks Does the price of $21,999 seem reasonable? Thanks

Hello Looking at a 2008 with 3600 hours on the meter. It has AC/heat, 15.8 in tracks, aux hi flow hydraulics and very clean looking outside. Might have been repainted. Says every thing works. Asking 21,995 or best. Is 3600 hours excessive? When do these things start to break on average? Thanks

Same problem I had. Solved with a half inch air impact wrench. Loosened immediately. My screen was almost totally plugged with gasket debris and the cow magnet was completely covered in metal filings.

New Holland has apparently changed their hydraulic filter supplier to a Mexican manufacturer. These filters are poorly made in my opinion. They are definitely not the quality of the previous USA made filters. I have had two back to back failures where the part that screws on to the machine has...

Thanks for the info. Hope it's a clogged screen. I'm worried now about damage I may have done to the pump because I let it run for about 15 minutes at an idle to warm it up before trying to move it. Thanks again.

The machine and the boom will not move. The Hydro charge light and buzzer are on continuously. Dip stick shows right on the mark full. Hydo fluid is clear. About two months ago it was fine, everything worked. Now it won't move. Any suggestions? Thanks

Hello Does anyone know where old dead skid steers go when they croak? I'm looking for the logic module for a New Holland L785 Skid steer. Surely there must be a old dead L785 or similar rotting somewhere with a functioning logic module in it. Six hundred fifty bucks for new one and a little less...

Thanks Mike10 for this really great post. Either my module is intermittently messing up or I had a low voltage hiccup. I became aware of a probable low voltage situation when I switched to "service mode" on the module and turned the key to start, the start relay would just click and stutter...

91+/- New Holland L785 Ford diesel will not start sometimes. The engine does not turn over. Battery voltage 12.8. Seat belt and seat switch work. All lights work on the panel as they should most of the time. Interestingly the unit will sometimes start after sitting overnight. New start switch...