Got everything put in and together, not a bad job at all. The new pins with the grease zerks in the ends work really well. I left the loader all the way in the air tonight we will see if it settles much in the morning I hope it don't. Thanks to everyone who replied for all the help. Lots of good...
I have a piston ring compressor and I should have the parts tomorrow. I also ordered the bottom pins with the grease zerks in the ends so I don't have to reach up I'm that hole anymore.
It a pain in the ass when ur trying to hold something in position and the loader keeps settling. The other day I was putting up some chutes and had to hold a couple hundred pound gate in position to get the bolts started and it would settle a lot faster with the weight on it.
The tilt and the lift both settle on my 2010 bobcat s205. I was wondering how I could tell wich cylinders r leaking so I could put new seals in them. There are no external leaks so it must be leaking by in one of the cylinders on both the tilt and lift.
I just purchased an 2010 s205 and I run it for quite awhile and the temp gauge just barely went over the first mark on the gauge. I was wondering if this is normal or my thermostat may be stuck open a little. The heat was warm but not as warm as my old s185 would get. I figure the gauge should...