So I forgot this little piece of information when I was trying to get it to start after I put the new fuel rail on I had the injector lines cracked so that I could purge the air out of the fuel rail and all of a sudden it started ran wide open about four seconds And then died and then wouldn’t...
So per the cat dealer, I have replaced the T in the top of the tank the complete transfer fuel pump assembly, new filter, etc., and the fuel rail
So I pulled up next to the work truck at the shop and filled up the machine and then a couple days later went to move it and it would not start it...
My first thought is your tension is to low
Try to Run them tighter
Don’t turn while in a hole or low spot
Turn in back and forth like a car
try to make turns while on a high spot
( while center of track is supported)
Pushing on a sideways on a steep slope is the worst
Try to work a hill in an...