Recent content by pkmx

Going to check it out today.machine stays at the farm/mx track so i drive over after work and work on it.thanks for the things to try.is there a way to post pics on here.

Machine is keyless and foot pedal.where is the run kill solenoid?the only one i see at back of engine is where the throttle linkage is it has three wires.

Hi Tazz, I found 2 solenoids on the control valve. I assume those are the spool locks. There is one solenoid on the back of engine near throttle control. It has three wires going to it. Is that the fuel and shutdown solenoid combined. I will ohm out all solenoids and see if they are bad. Will...

it will not even try to start.when i enter code it beeps 3 or 4 times.also it says "spool lock output short to ground" i put "speed"in prev post,thanks

I have a t300 and it was working fine. Then all the sudden it quit. I tried to start it back up but it gave me these three errors: "Speed Lock Output short to ground" "Fuel Shutoff sol pull error on" "Fuel shutoff sol hold open circuit" Where should I start??? I have looked around for some...