Recent content by Mike12

I picked up a maradyne 12,500 btu heater NIB on ebay for 99.00 plus shipping to about 2 hours to install and plumb in since I chose not to remove the rops when installing

Sorry for the late reply but I,m out of town for work I belive they were 1/4inch or 3/8 stainless I just pulled the plugt out ner the front of the engine and took it to Napa they matched it up.

Any good diesel shop should have one and alot cheaper than Case. Last winter fuel shut off solenoid went bad on my 1840 139.00 at case local diesel shop 35.00 for the same Bosch solenoid.

Forgot to add those are the same places I plumed mine in at. So I guess pics are redundant but if you want them let me know and Ill post them.

I just installed a heater in my 1840 I will take some pics tomorrow and post them of where it is plumed in I just have a soft cab but it was about 18 degrees here today and moving some hay and on low I was in a t shirt and jeans and sweating it was so hot on low. The fittings that go into the...

Or you might be able to figure it out from this decent parts break down for 1530 on this link. http://www.messicks.com/CAS/67863.aspx

Here's a link for a service manual http://www.tractorpartsasap.com/Service_Manual_Case_Skid_Steers_1500_1526_1530_p/122578.htm On my 1840 its on the right hand side just inside the rear door big silver vented cap

Both cylinders were seeping very little out of the end and one day moving some hay for the wife's horses oil just started spewing out of one cylinder so figured I might as well do both since the other was seeping and would probably crap out at the worst possible time.

Had the same problems on my 1840 found seal kits on eBay for 11$ local hydraulics shop rebuilt and pressure tested both cylinders for $120 no problems now. Also might want to check for leaky hoses.

Alright guys I need some advice after freezing my azz of the last 2 years moving hay and snow around for the wife's horses I'm going to put some type of cab on my 1840. I have two choices the Cardinal canvas cab which seems well made cost of 349.00 or the lexan cab kit that the guy Scott was on...

X2 my 1840 did the same thing had the battery load tested and it was shot. New battery no more annoying buzz.

Pull out the floor plate locate the rubber boot that goes over where the parking brake pin gets inserted into the sprocket. Disconnect the cable then remove the U shaped pin that the holds the pin assembly in place. Remove the pin asse4mbly and see what needs fixing. Is your brake not releasing...

A big thank you to all of you for your knowledge and help from someone who only bought a skid steer in order to help keep up with the wifes horses pain in the a$$. I have fixed all of the problems I have had in the last year with help from people on this site. Lol I now have alot of tools that I...

I have a 1995 model that I assume is the same I had had to adjust the screws in the pin to get mine to stop doing exactly what are talking about. If you take out the floor plate you can follow the lines to the pins which are covered with a rubber boot. They say to put it on blocks to do this but...

I'll scan in an post the pages from the service manual that apply over the weekend if I don't get tied up with other stuff.