Recent content by Joel804

Yeah. I took it with me when i got the parts. They were able to get it as all fixed now and works properlypart for me. It

I got the lift spool valve out and the detent sleeve is stuck on it. It will spin but wont pull back. Any advise please.

So I got the spool out and the detent sleeve is stuck on it. Is there something I can do besides cut it off?

Yeah I was watching his video. Mine had no spring or balls. to the bobcat store i go tomorrow lol

So it pops into place but imediatly pops back out. Im going to try ro check the detent balls

Hello. I have a 99 873 F. It wont go into float. This thing has very low hours 840. So my question is could something be stuck due to not being used. When i first got it the aux only worked in 1 direction. I cleaned the aux valves and it works like it should. 1 was stuck. So I am wondering if...

They are Grouser tracks. It makes the it a totally different machine. Tears up the ground a lot though

74 I believe

You are absolutely right my friend. Thanks for the coment

Its been a week or so because of weather. But got to run my 873 for a little bit today. Shes dirty but thats original paint and decals.

Good for you bud. I hope you enjoy it and it treats you well.

I’m not sure. I just did a Quick Look up and see them priced from $14k - 23k

Look over the whole unit. Make sure you have some time to inspect it. Take covers off and look at the wheel motors for any leaks etc etc. good luck

Yeah well. They were asking $15 k and took the 10k I brought with me. I think I got pretty lucky. But good luck in your search. I hope it goes well.