Recent content by isoscell

HI, can you send a picture from the joystick?

Hi, visit our website www.isoscell.com Our technicians will try to advise you.

Hi, your controller can be repaired. Repair time 1 day. 1 year warranty. Visit www.isoscell.com for request repair. Thank you

Hi, maybe your controller is defective. please contact us for troubleshooting instructions, visit our website www.isoscell.com

Hi Glean, your description contains little info to understand where the cause is. To try to help you I will need to know the serial number of the machine, the errors obtained (if you receive them). It would also be good to see if the seat bar works. What was the dealer's summary? You can leave...

This problem is 100% caused by the controller. These machines can have 2 types of controller, with four connectors or with two. I think your machine has a controller with 2 connectors because this problem is often encountered in these. Because these controllers are filled with epoxy, over...

I look here that a lot of time is wasted finding the cause. the simplest and safest, send all three units to us for testing / repair. www.ISOSCELL.com

I look here that a lot of time is wasted finding the cause. the simplest and safest, send all three units to us for testing / repair. www.ISOSCELL.com

Do a simple test, check how many volts you get at the engine temperature sensor connector (with the sensor disconnected), it should be 8v. If it is more or less, it turns out that you have a faulty controller. This controller can be repaired guaranteed at www.isoscell.com

Hi, this defect is common in these machines, the cause is the controller. Do a simple test, check how many volts you get at the engine temperature sensor connector (with the sensor disconnected), it should be 8v. If it is more or less, it turns out that you have a faulty controller. This...

Hi, contact us, we will give you diagram. www.isoscell.com

Hi, we have extensive experience in repairing Bobcat equipment. We will try to help you. So, if the "lift & tilt valve" LED on the left panel is off, there is a fault on the "hyd. Lock solenoid" circuit. If you press and hold the "light" button (to get the error code) you get NONE, then you may...