Recent content by ih-1

ok ,I talked to the guy (skid steer solutions) that sells the terra mowers on ebay and he said they just finished testing and they no longer require the return for bobcats.I dont know what to do now. I got hoses and hooked it up and it runs fine and when you stop(let of switch) just a dribble...

ok finally getting around to installing this mower to see if it works.I have to install a case drain as the mower has 3 lines to it. has anyone ever done this? can I go back to the filter and tap in there instead of at the case itself? isnt one of the filters on the return side? could I just T a...

I have been wanting one also but can`t stomach the $6000. like the ones on ebay.what was the brand you are looking at? I just bought a toro 4500d rough cut mower (golf coarse) that has 5 26" finish mower decks that are hyd. driven. my plan is to make one fit my 331. I realize it wont be for...

it didn`t look like much ,it was kinda greasy ,didn`t look like fresh metal.

well I think that was it . I took it out and cleaned it and re-installed and set. the mid range speed was ok with no alert but after a couple min of running I raised the rpm and it did it again. I took it back out and the end was covered with crap again (magnet) cleaned and put back in and seems...

ahh, I see you mentioned that now.sorry I missed it. off to give it a try today and see if it works. Thanks

wow thanks ,thats the part I was trying to describe in an above post but couldn`t find it in the manual either. in the last text before the "note" do you tighten the nut back down after setting to hold it? it does`t say? Thanks

ok ,found the code chart in my manual and 10 is gigh speed ,11 is very high speed. still can`t find the sensor in the book or what its called for sure. engine isn`t reving high .

ok tried that and it said "none" then when I got to about half throttle for a few seconds it beeped and light came on ,hour meter said 06-10 then at higher rpm ,close to full throttle it said 16-11. is the sensor above the drive belt cover on left side of engine? looks like a big bolt with a...

ok Thanks ,must be on the lines of what you said since the speed is half throttle or above. I`ll read into that. Thanks again.

Hello, new user but have been reading here a while and finally had a problem. I have a 773G w/turbo ser# 519023576 . last fall this happened once and then never again until this week. I got the warning light on top right panel,the one that looks like an exclamation point. solid beep with...