Recent content by Hardknockers

This loader does not have the aux hyd

I have followed ever visible wire, excluding inside the loom, and all looks good, no bare wire or breaks...I have take a die grinder with abrasive wheel and cleaned all visible connections. Short of pulling all that wire out of the loader frame and loom I am puzzled and can't figure this thing out

I would have to agree on the weak connection. Are there any relays/sensors/solenoinds that would keep it from running if lets say: the oil was low, or perhaps filters are full and plugged ...I'm just thinkin outloud.....I do have a generator that will not run if oil is low, that what makes me...

nothing....do the dashboards ever go bad, becasue, there are time when i throw the switch, I will see the lights light up for a split second and then disappear and all goes dead

Fuse looks good, its clean and not corroded...there are a slu of wires in a loom that follow the rail up the the switch, and looks like it could be a real pain to expose them...the loom looks clean and good, but havent pulled any wires out of it yet to see if there are any breaks... I was hoping...

Thats just it, where are all the relays located, if there are any. I'm not seeing them

Loader will not start now. I have been having trouble with the thing dying, but will start right back up. When it dies, I loose all power according to the dashboard. I thought it was in the switch so i replaced it, plus the solenoid and the battery cables, which seemed to help for last 6 days...