Recent content by Delmer

Tazza, you had identified it in your first response, I just didn't know enough for what to look for specifically.

I finally got it! Minus the time, the cost was around $6 for a couple springs from the hardware store. On the advice of someone who had a similar issue I pulled the load checks from the valve body - the springs in them were compressed and broken. On my machine these are the two 7/8" plugs on the...

Bump

I took the loader control apart and pulled the valve rods. In my case they were in perfect condition, I couldn't see any ridge or wear. Any other thoughts?

Thanks Tazza, I'll explore the control block possibility. I most definitely could be wrong, but it doesn't seem like it could be a piston seal. The loader stays up fine if nothing is done with the controls. It's only when I try to inch up a little higher that it will drop - till I move the lever...

On my Case 1845C, as I begin lifting a heavy load, my lift arms will actually begin to drop. If I increase the rate at which I lift it will stop descending and lift as it should. Any ideas on what is causing this? Any photos or parts diagrams? Thanks, Delmer