Recent content by ChickenHouseMaster

Just wanted to let everyone know I enjoy this site and Willing to help with anything bobcat. We've owned bobcat skid loaders since 1980. Do all the work on them ourselves in our shop, from rebuilding motors, cylinders, drive motors, hydralic pumps, and everything else on the bobcat. Have years...

Just looking for used parts that are good condition to save some money on this rebuild. Let me know what you got. Items needed: 2 tracks Alternator Water pump Starter Door latch don't need the outside handle just the inside parts Fuel shutoff solenoid Drive motor And I need 2 bob tach plates...

Ya if its from your control block its most likely your spool seals have gone bad. Happens alot over time I've replaced mine on my 2 05 t190s. Not the easiest thing to do but if you know what your doing you can do it yourself and save lots of money.

^^^^ yea check out that website I purchase parts from there all the time when I can avoid the dealer. Great prices, and service and same parts bobcat offers minus the dealer pricetag. Fast shipping to^^^^^

Check battery voltage under a load should stay at 13.0 volts maybe a little more but has to have over 12.5 most of the time to turn over

That motor shouldnt move any if all the motor mounts are on the engine and hydrostats. If there all on there you couldn't yank it out of there with a chain and a truck I assure you.

Check all your pressures: engine oil, hydraulic oil, system voltage, engine temp, and cooling system. All reasons it would go into shut down mode. Could be a faulty sensor but you will see which one it is by checking all of the things I listed

What kind of work do you do with them if you don't mind me asking? I've got 2 2005 t190s I bought new and let me tell you they are expensive to maintain. Great machines but expensive to maintain. I do all the work on them and other machines so if you ever need anything or have questions I'll be...

You'll have one visible case drain on the left side of the machine underneath the cab if your looking from the front. Your other one should be up under the hydraulic tank on the right side of the machine. Check your hydraulic pressure sensor I had one go bad and did the same thing until I...