Recent content by Blaine Man

I have a 5625 but it does not move very much, enough you notice it during warm up. I put on a new front brake cable thinking that may help but it did not. The calipers are really hard to access to remove for pad replacement which after 20 years are probably oiled up and deuterated. Then the pads...

That is one design flaw for that model when they did not have the lube fill plugs on both sides of the motor. You can get to the one side easy by removing the floor pan. The other side you lift the cage and must remove a large hydraulic hose to gain almost blind access.

See my post about my 5625, might be the same, a simple fix.

Congratulations on you new toy. The hazy plastic can be cleared up by a Toothbrush and Toothpaste, use to work on the 70's convertibles.

It was a bad hot wire lead going into the 30 amp fuse. Both ends were corroded on the wires. These fuses are not easy to find, be sure to keep a spare or you could be down for a couple days. Just for the sake of future knowledge a decade down the road. The left hand fuel filter mounted on the...

Cool, I never heard that trick, I will give it a try. First has to be taking the air cleaner off and see if that could be it, then the fuel/electrical.

It is the same condition trying to cold start it. Today is to bad of day to get into it with it due to heat and thunder storms coming. I will contact my guy that rebuilds my injection pumps, he is pretty knowledgeable about injection systems. The remote starter will be easy to hook up so no help...

Just happened yesterday at the worst place, was only running the machine for 10 minutes before dying. I have been working it hard for the past week for two hours a day. I do have fresh fuel and completely new filters installed for everything. It runs for two seconds then dies every time I turn...

Any luck with the creeping? I am anxiously awaiting your result due to mine having a slight creeping also,

My sticker is also missing and could not find any other numbers. You can download the OM from a post I recently answered. Mine has a small amount of movement to the right also during warm up, about one inch per minute. Put on a new front brake cable but it is still doing it. I will be watching...

https://www.manualslib.com/manual/1046725/Gehl-5625sx.html

https://www.manualslib.com/manual/819954/Gehl-5625.html#manual

This site is messed up, it will not leave spaces for the two sites!

https://www.manualslib.com/manual/819954/Gehl-5625.html#manual https://www.manualslib.com/manual/1046725/Gehl-5625sx.html If you can not understand the internet then forget it, I can not make it any clearer, it's free.

I just printed it out, no problem if you have a good printer that can do both front and back of the page. I downloaded it to my computer then printed it out.