Recent content by bkg

Tazza - thanks again for the tip. Found the right spot, zipped tied in place and then tied the switch to the wiring harness (rather than leaving in stock location) and all is good!! Thanks again!

Tazza - Thank you. Appreciate the input. I'll give this a try and see if it gets me anywhere! I noticed it's a bit of an odd design - and the service manual "instructions" are backwards as compared to my sensor.

Hey all, Been reading the previous BICS threads, but they haven't addressed my challenge, so I'm starting thread 12,244,244 on BICS. 1995 773. Started solenoid went out and that began a repair-turned-OCD driven "20-foot" restoration. new tires/wheels, few new pins, new belts, all fluids replaced...

Well... Won't fit w/o mods. Pulled the 773 in and test fit after tacking. Arms are 2" to low to clear boom and 5" too short to reach the ball mounts. Guess that explains the mods. Oh well. Going to have to make the mods. And if I eventually replace the 773 (plan for next year), I'll just have to...

Single tilt cylinder. When mounted on the bobcat, should the boom be all the way down, or up a couple of inches. PO had raised the hitches on the 909 about 2". Thanks again

Hey all. Finally getting around to rebuilding my cobbled 909. The outrigger attachment arms had been cut and raises... Poorly. Two questions. 1. Does anyone know if the 909 fit the mid-size 773 in stock form? Or only the smaller units? 2. If the answer to 1 is "yes" I need a measurement. The...