Recent content by bigcam

I tried separating them links but the forum put them all together :( There are 4 separate links there. https is the start of each link. Im not sure how to keep them separated?

It has been many years but i am still replying to emails as i said i would. Al though i don't reply real fast some times. Life gets busy and that email is no longer my main used email anymore so i don't check it as often. But i still do. It was so much easier when the link would stay working on...

Yea i am sure by now it got removed. send me a email at [email protected] Put in the subject "mustang 1200" so i don't send it strait to the spam folder. Also i have the OPERATORS manual not the repair manual. It has most of what you would need tho. I have a paper version of the parts...

Rereading your post here i seen something about rebuilding a hydraulic cylinder to. heres where i got a couple rebuild kits from. Cost me $20 a cylinder. https://www.baumhydraulics.com/home.php?cat=22 Atlest for me they shipped it super fast.

My old belt was extremely stretched lol If i tried to go to low speed the belt would just flop on the pulleys. also the belt was 1/2 inch narrower then it was when new. The 1200 is setup a bit different then yours tho. My drive pulley is right off the crank shaft and i am able to slide the...

belt part number 2926V686 does for sure fit the 1200. I bought it and installed it. works great now. OMC part number is 020-26433. so i would guess not the same belt being different part number. all you do to convert OMC part number to john deere is ad GG in the front of the number. So you will...

adding more helpful info here. belt part number 2926V686 does for sure fit this 1200. I bought it and installed it. works great now. OMC part number is 020-26433

you don't have to go back to the manufacture for the clutch. actually if you call john deere like i did they will say they cant get it but gahl can at a cost of over 700 per clutch. or you can go to http://www.tribco.com/ and tell them part number JD600. that is the friction disks at just under...

Another neat thing i figured out. if your looking up parts using gahl mustang numbers you just add 2 letter "G" in front of mustangs/gahl number. then it is a johndeere number and may show up more results.

So i decided to figure out what the clutch cost in these. That was a long drug out search haha. But to help the next guy This company makes the friction clutch disks and the separation plates. http://www.tribco.com/ Call them up and give them part number JD600. Each friction disk at the time of...

From what i dug up online this belt is the right length but a 1/16 wider then the original belt. what i dug up said the factory belt was 68.6 x 1 3/4 I dont know if it will work but i think i mite try it. If someone els wants to take there chances here ya go...

Ok i uploaded the operators manual to dropbox. heres the link to download it. After you download it you will need a password to view it. yea the password is a really annoying idea but i don't know how to remove it. Password is>>> A0021OWO@J5i...

ohh and someone please try it so i know it works!

Ok i uploaded the operators manual to dropbox. heres the link to down load it. After you download it you will need a password to view it. yea the password is a really annoying idea but i don't know how to remove it. Password is>>> A0021OWO@J5i...

How do i upload a PDF file on here?