Recent content by badm371

thank you hot rod I got clutch disc,s for bobcat skid steer 371 from loader parts source I do not need them but I have them no hunting I got parts I found wheel bearings ptlm 501349 8 bucks each and rollers for the drive sprockets they are Torrington b2020 10 bucks the best axle seals bobcat 9...

does anyone know the Timken seal number for m371 thanks

has anyone done the wheel bearing on the m371 or 310 I was wounding on where was best place and price for them mine leak a little but no wobble nice and tight my friend says control leakage lol I guess the seals go bad after 30 years or so , so I should not try to talk myself out of at least...

I got confused with the numbers the 743 I rented ,anyways I do not know how the numbers go but for me a smaller machine is good I can get in the back yard and it does not scare the crap out of the home owner ,some like diesel some like gas

I seen one on cregslist in florida I am drooling the add says 2500 a 2002 I could not be leave it you could eat off the motor and new filters on it the numbers marked on the bottom of them look new any ways I used to rent the 763 not to big not to small my lil 371 was all rusty when I got it...

the 743 is a nice machine I was looking to buy one but somehow I wanted the little 310 it would be great for back yards ect but found the m371 and 4 inches larger and the guy selling promised it was a good little machine I have no complaints

mine is chain driven and a belt it has two speed but I have to move the belt to put in hold on to my butt mode

he just stopped by to make sure I did not knock myself out on the bucket lol witch I did I seen the light I have not been hit that hard in awhile

I do thank everyone on this site I was able to pick little bits of information on my machine to make the tear down easer that is why I joined hoping I could offer a little help to someone who needs it I have a friend who is master tec over 25 years

I went to loader parts and sent message I have had my machine 2 years and first time something went wrong

ok it will not hurt to ask if clutch lining getting thin best to get it now Bobcat 371 if not to busy I know you did you wheel bearing where did you get parts and around how much $$$$ thank you

Hello from sunny florida but darn it is cold

I checked whit a feeler gauge my clutch's had a 28 thousand but 30 thousand would be ok between clutch disc and out side clutch I checked so I would have a reference point when I put it back together I would love to know the thickness of a new clutch lining for bobcat skid steer m371 so I know...

I am going to put new wheel bearings and seals in while I have it apart does anyone have the bearing numbers and seal numbers thanks badm371

I am tearing all the clutches off to put new drive sprocket needle bearings in the sprockets have a Torrington B -2020 the 310 should be the same a easy machine to work on with all the chains on it was over whelming just go slow and take plenty of pictures IF ANYONE NEEDS HELP WITH THE M371...