|
Re: Bobcat 773 hand control problem
5/14/2013 8:03:16 PM
(Total replies: 1)
|
| I had a similar problem with AHC machine. It took awhile to find that the problem was just a bad ground in the cluster of small ground wires attached to the starter. I traced the bad ground wire back to the metal AHC computer. |
|
|
|
Re: S-185..Dead in the water
4/25/2013 7:06:21 PM
(Total replies: 1)
|
| What was the code? When it shuts down, Push and hold the "lights button" There is code. |
|
|
|
Re: t300 no hydraulics code 05-15
5/25/2012 11:59:04 PM
(Total replies: 1)
|
| If you're getting a 05-15 code with no other warnings before is shuts down. I would check the hydro pump shaft/ pulley. could be a sheared pulley on the hydro shaft? |
|
|
|
|
|
|
Re: 341 swivel joint
12/29/2011 7:57:59 PM
(Total replies: 1)
|
| My answer is. B4 U take it to a dealer. Get under the machine and "spot the leak". To "repair a swivel joint" is huge. Check the house swing motor carrier. It could be leaking. Still.Not Easey to change out |
|
|
|
Re: T300 Loud Pump Noise
6/8/2012 7:11:36 PM
(Total replies: 1)
|
| Seen a T300, Late model. A rear track idler had broken away, and took a chunk out of the carrage. Only made noise when the machine was going up hill, or under load. |
|
|
|
Re: HELP 773G NOT UNLOCKING THE HARM BAR.
5/1/2012 6:20:47 PM
(Total replies: 1)
|
| Turn the Key on. "Push and Hold", the Lights button. The left screen will say "NONE". Start the machine. Be ready to remember the error code numbers. This is where to start. If you want to call your local dealer. They need to know the serial# of your machine and the code you,re getting. If you don't want to call a dealer,Post the code. |
|
|
|
|
|
|
Re: HELP 773G NOT UNLOCKING THE HARM BAR.
5/7/2012 8:25:55 PM
(Total replies: 1)
|
| 4-14,and 4-15 R, engine oil pressure codes. Extremley low, and in shut down. Sorry, but please, slow down. These codes will shutdown the machine,before you can lowwer the arm bar. |
|
|
|
Re: 2003 s250 bobcat
2/12/2013 8:46:05 PM
(Total replies: 0)
|
| I'm thinking U have a charge pressure issue. check out the operators manual,for that code. It kills the motor to protect the hyd/hydro's. Whats the code? |
|
